My signals are not working (I am putting some on, the last dude took them off.) I found a plug that goes to the tail light that has 3 wires coming off of of the plug that are capped...I think those are the blinker wires . When I press the blinkers left or right, nothing happens on the tank, and not voltage at the flasher or blinker switch. I checked the bulbs straight to the battery and they are good. Any ideas?
you should have 4 wires 2 grounds, a left and right blinker wire. Check the service manual wiring diagrams for wire colors. I'm sure I'm sure that there is a link to it here some where.
I would also check the ground. Most aftermarket lights use the body of the light expecting the body of the bike to be common ground. That's not always the case with the amount of plastic on bikes today. try running a jumper wire from the -ve terminal to the body of the light if it works that tells you that you have to ground the light.
Dude.
Nice picture.
I forgot...what was the question?
bump
Did you try grounding out the signals?
Yes, that's not it. It is somewhere deeper. When you turn the key on, does your signal indicator turn on, on your control panel? Mine doesn't. Also, is the flasher relay attached right next to the battery?
You must log in to post.