Motorcycle Club » General Forum

Removing a crank shaft nut, changing clutch shaft bearing?

1 post from 1 voice
About This Topic
  1. rkgsmith66
    #

    I need to remove the crank shaft nut to replace an impeller gear for the water pump. I removed the case cover on the other side to put a wrench on the crank nut on that side so the nuts won't turn. However it is very tight. Do I need to use an impact wrench to remove this nut. Also what is involved in changing the seal to the clutch shaft where it enters the engine. thanks.

Reply

You must log in to post.