hello...my 1100 cruiser fell over on its side while parked; and when i picked it back up my bike escaped damaged but my handle bars are slightly cock-eyed
(not exactly straight)...can i get some advice from this forum on how do i straighten my bars back to its origonal position ...the bars are not bent just
slightly out of alignment...over2u
hello...my 1100 cruiser fell over on its side while parked; and when i picked it back up my bike escaped damaged but my handle bars are slightly cock-eyed(not exactly straight)...can i get some advice from this forum on how do i straighten my bars back to its origonal position ...the bars are not bent just slightly out of alignment...over2u
I just changed my stock bars on my 08 custom so if you wanna buy them lemme know
I just changed my stock bars on my 08 custom so if you wanna buy them lemme know
...i need to know what bolts to loosen
so i can tweak them back to where they were.
Are they tweeked forward or rear, or twisted so they are not perpendicular to the wheel? If front to rear then loosen the bolts that are under the caps where they attach to the upper triple tree. if twisted the loosen the bolts where the fork tubes pass through the triple trees square it all up and retighten to specs.
thanks for your reply...one side is tweaked slightly backward compared to the other...BUT how do i loosen the clamps if there doesn't look like i have access to loosen them??? over2u
You must log in to post.