center stand
8 posts from 8 voices-
is there one made for this bike? will one from another bike fit?
-
no and no
not that i know anyway there is a thread here somewhere about it
most use the jacks or stands if there storin there bike or workin on it
but if ya find one tell us all
welcome to the forum as well
when you get a chance go to the new rider forum and post a bit about yourself
-
I found this thread, haven't used it yet but it is getting to be that time here also. Thought I would give it a shot.
nightrider.com/biketech/bikelift.htm
-
there are holes there to mount something so i suggest that you could make one without too much difficulty
-
I found this thread, haven't used it yet but it...
Works good for repairs, but only gets one wheel all the way off the ground at a time. -
Some more info here...
sloneservices.com/SilverBack/VStar1100-FAQ-04.htm#Jacks-Stands
-
With the loops on the under side, it looks like there was some thought put into having one stock on the bike. Perhaps a carry-over from the Virago frame, or it might be to jig it while manufacturing. I'd try the Virago route and see if you can get one at a motorcycle salvage yd. I think the V-Star sits a little lower than a Virago, so it might need to be shortened.
-
With the loops on the under side, it looks like...
I've read that those mounts are used to mount the bike to the crate when it is shipped to the dealers.
Reply
You must log in to post.